Calculated Industries 6130 v3.0 - Manual (Page 24)

4) Press [Set] to save changes and put
the unit into auto-count measuring
mode.
5) Roll a distance. The unit will beep
each time you roll the programmed
distance. The count number in the
scale box will increment.*
6) Press [Set] [Count] or [Set] [Reset]
[Count] to exit auto-count mode.
*Note: The count number will increment
until it reaches 999; after that, an
asterisk (*) will appear in the scale
box display and the unit will con-
tinue counting from one. To display
the total accumulated count num-
ber on the main display, press [Rcl]
[Count].
Press [Count] again (i.e.,
[Rcl] [Count] [Count] ) to recall the
set auto-count value.
24 – Scale Master ® II v3.0