Calculated Industries 6130 v3.0 - Manual (Page 27)

Finding Area and Volume
The Scale Master II can calculate area
and volume once you have your values
set for length, width, and (for volume
calculation only) height. The length,
width and height register values are
stored in semi-permanent memory.
These values will not be cleared when
you press
[Reset] by itself. These values
will only clear if you:
1) Turn off the unit (clears length
and width only).
2) Press [Reset] then the register
(clears one value at a time).
3) Press [Sub] and [Reset]
simultaneously (clears all values).
Once you have rolled or set your
height value, it will be used for all sub-
sequent volume calculations unless
you change it.
Finding Area
1) Roll the first dimension and press
[Length] . This value is stored as the
length and the main display will
reset to zero (0).
27 – User’s Guide