Calculated Industries 6130 v3.0 - Manual (Page 28)

2) Roll the second dimension and
press [Width] . This value is stored
as the width and the main display
will reset to zero.
3) Press [Sq/Cu] to calculate the area.
Finding Volume
1) Roll the first dimension and press
[Length] .
2) Roll the second dimension and
press [Width].
3) Storing a height value (if you have
previously set a height, skip to step 4):
a. To Roll and Store a Height:
i. Roll the third dimension and
press [Set] [SQ/CU]. The display
will show the rolled value and
the unit of measure will begin
flashing.
ii. If you do not want to change
the unit of measure, go to
step iii. To change the unit of
measure, press [M+] until you
reach the desired unit.
iii. Press [Set] to set the value as
height and the display will
clear to zero.
28 – Scale Master ® II v3.0