Metrohm 798 MPT Titrino - Manual (Page 111)

3.2 Remote control commands
798 MPT Titrino
107
3.2.2.53. MemoryCard.Recall $G
MemoryCard.Recall.Name up to 8 ASCII characters
MemoryCard.Store $G
MemoryCard.Store.Name up to 8 ASCII characters
MemoryCard.Delete $G
MemoryCard.Delete.Name up to 8 ASCII characters
Administration of the method memory of the current directory of the memory
card: load, store and delete methods. The action is carried out, if "$G" is
transmitted to the corresponding node.
Do not use blank characters before and after method name!
3.2.2.54. MemoryCard.ChangeDir $G
MemoryCard.ChangeDir.Name up to 10 ASCII characters
MemoryCard.ChangeDir.Checksum $G
MemoryCard.ChangeDir.Checksum.Value read only
Changing the current directory. The action is carried out if "$G" is transmitted
to the corresponding node.
Do not use blank characters before and after name!
The checksum characterizes the content of the directory.
3.2.2.55. MemoryCard.CreateDir $G
MemoryCard.CreateDir.Name up to 10 ASCII characters
Delete directory. The action is carried out if "$G" is transmitted to the corre-
sponding node.
Do not use blank characters before and after name!
3.2.2.56. MemoryCard.DelDir $G
MemoryCard.DelDir.Name up to 10 ASCII characters
Delete directory. The action is carried out if "$G" is transmitted to the corre-
sponding node.
Do not use blank characters before and after name!
3.2.2.57. MemoryCard.Backup $G
MemoryCard.Backup.Name up to 10 ASCII characters
Backup of the internal memory onto the card. The action is carried out if "$G"
is transmitted to the corresponding node.
Do not use blank characters before and after name!
3.2.2.58. MemoryCard.Reload $G
MemoryCard.Reload.Name up to 10 ASCII characters
Reload a backup from the memory card into the internal memory. The action
is carried out if "$G" is transmitted to the corresponding node.
Do not use blank characters before and after name!
3.2.2.59. MemoryCard.Format $G
MemoryCard.CardLabel.Name up to 8 ASCII characters