4 mounting the exhaust air collection tube, Mounting the exhaust air collection tube – Metrohm 895 Professional PVC Thermomat User Manual
Page 22
3.2 Mounting accessories
■■■■■■■■■■■■■■■■■■■■■■
14
■■■■■■■■
895 Professional PVC Thermomat
NOTE
The optional clear glass measuring vessels (6.1428.030)
[Link target not
found in publication context!]
may also be used in place of the polystyr-
ene measuring vessel (6.1428.107).
In contrast to the polystyrene vessel, the measuring vessel (6.1428.030)
can also be cleaned with acetone.
3.2.4
Mounting the exhaust air collection tube
The optional exhaust air collection tube (6.2757.000)
[Link target not
found in publication context!]
can be mounted on the 895 Professional
PVC Thermomat for targeted removal of the exhaust air.
NOTE
A total of 8 pieces of silicone tubing (6.1816.010) (220 mm) are
required in addition to the exhaust air collection tube.
Proceed as follows to mount the collection tube:
1 Mounting the exhaust air collection tube
■
Insert the exhaust air collection tube with both support pins into
the collection tube holders on the 895 Professional PVC Thermo-
mat in such a way that the connector to the exhaust air removal is
located to the rear.
2 Connecting the measuring vessels
■
Screw the M8/olive tubing adapter into the Out opening of the
measuring vessel cover.
■
Connect one end of the silicone tubing to the M8/olive tubing
adapter.
■
Insert the other end of the silicone tubing into the corresponding
opening on the collection tube.
■
Seal the unused openings on the collection tube with the
enclosed stoppers.
3 Connecting the exhaust air collection tube
■
Connect a suitable tubing to the connector of the exhaust air col-
lection tube and connect it to an active suction device (e.g. water
jet pump).