Metrohm 840 PC Control 6.0 / Touch Control - Manual (Page 10)

1.1 Reagents ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 ￭￭￭￭￭￭￭￭
[Reagent exchange]
Edit the parameters for the reagent exchange.
Dialog "Reagent monitoring / Status"
In this dialog the current values of the reagent monitoring are displayed.
[Reset]
Reset the values to zero.
Dialog "Reagent monitoring / Reagent exchange"
In this dialog the parameters for the reagent exchange are defined.
Reagent exchange
The reagent can either be exchanged manually or automatically.
Selection manual | auto
Default value manual
manual
If a monitored parameter has reached the limit set, a message is being
displayed. Then the reagent has to be exchanged manually.
auto
If a monitored parameter has reached the limit set, the method defined
below is started automatically.
Memory
This parameter can only be edited when Reagent exchange = auto.
Memory location the method is loaded from. All memory locations are
selectable, even if they are currently not accessible.
Selection Internal memory | Card 1 | Card 2 | Shared
memory
Default value Internal memory
Shared memory
Memory released on an external system. For this an 847 USB Lab Link
is necessary.
Method
This parameter can only be edited when Reagent exchange = auto.
Method used for emptying the titration cell.
Note
Make sure that the memory is accessible.