Buffalo Technology WLA-L11 - Manual (Page 45)

WLA-L11 User’s Manual 43
.
Cause (1)
The entered MAC address is incorrect when the AirStation is set from the wireless LAN per-
sonal computer.
Remedy (1)
Check and reenter the AirStation’s MAC address.
For the MAC address, refer to the Parts Nomenclature and Functions section in
Install Manual.
The factory-set group name is "Group". If you are setting for the first time, or have not
changed the group name, check if it is set to "Group" or not.
Cause (2)
The hub and the AirStation are not connected when the AirStation is set from the Ethernet
LAN personal computer.
Remedy (2)
• Check that the hub and the AirStation are firmly connected using a UTP straight cable. (Insert the cable
until you hear a click.)
• Be sure to use a UTP straight cable to connect the AirStation and personal computers to the hub.
Cause (3)
The cable is broken.
Remedy (3)
Reconnect using good UTP straight cable.
Cause (4)
The hub is malfunctioning.
Remedy (4)
• Check if the AirStation and the hub Link lamps are flashing.
• Try connecting the another port on the hub.
Cause (5)
The communication mode for the connected hub and the AirStation is different.
Remedy (5)
Some hubs may not be able to connect correctly to the network using the Auto Negotiation set-
ting. If this occurs, you must set the communications mode manually. Change the setting to
other than Auto Negotiation. If you change the setting and there is still a communications prob-
lem, and you can change the hub communications mode, change the hub communications
mode manually to be the same as the AirStation’s mode.
To change the AirStation’s communications mode, refer to the "Setting Method" section (page
37) in Chapter 2, What is Next?
"Cannot Find AirStation" Is Displayed When Starting the
Easy Installation Wizard