Baseline Systems BaseStation 6000 - Manual (Page 83)

P a g e | 75
5. In the Starting Zone field, click the up arrow or down arrow (4) so that the zone where
you want the test to start is visible in the field.
6. Type a number in the On Time In Seconds (5) field to indicate how long each zone will
run during the walk around test.
7. Type a number in the Seconds before Starting field to indicate how long the system will
wait before starting the first zone. This delay gives you time to go to the zone location so
you can observe the test.
8. When you are ready to begin the walk around test, click Start (6) . If necessary, you can
click Pause or Cancel to stop the walk around test.