Baseline Systems BHM Series Hydrometer - Manual (Page 3)

Table of Contents
INTRODUCTION
General Description ............................................................4
Water Meter/Registers .........................................................4
Hydraulic Valve (Flow Sensor) ...........................................4
Specifications and Dimensions ...........................................5
Netafim USA Hydrometers with Electrical Output ............7
Electrical Output Specifications (Reed Switch Reg.) .........7
Transducer Type ................................................................10
Hydrometer Internal Components .....................................12
INSTALLATION
A. Installation Requirements .............................................13
B. Unpacking ....................................................................13
C. Pipeline Installation ......................................................13
D. Preliminary Steps .........................................................13
E. Installing 1 ½” and 2” Models ......................................13
F. Installing 3” – 8” Models ..............................................13
CONTROL SYSTEM
A. Solenoid Connection ....................................................14
B. Electrical Output ..........................................................14
DRAINAGE VALVE .......................................................15
OPERATIONAL TESTING
A. To test water flow and manual operation .....................16
B. To test automatic and remote operation .......................16
OPERATIONS
A. Manual Operation ........................................................17
B. Automatic Operation ....................................................17
C. Solenoid Operation .......................................................17
TYPICAL APPLICATIONS
Pressure Sustaining ...........................................................18
Pressure Reducing .............................................................19
TROUBLESHOOTING
A. Leakage from Hydrometer Connection to Pipeline .....20
B. No Electrical Output Signal from Hydrometer ............20
C. Controller Indicates Water Not Flowing as Instructed .20
D. No Indication of Flow on Meter Dial ...........................20
E. Controller Indicates Valve Opening Failure .................21
F. Controller Indicates Valve Closure Failure ...................21
G. Leakage from Valves or Connectors ............................21
H. Constant Drainage from Pilot Valve ............................21
I. Excess or Insufficient Output Pressure ..........................22
J. Excess or Insufficient Input Pressure ............................22
K. Excess or Insufficient Flow Rate .................................22
MAINTENANCE PREPARATION
Preliminary Steps ..............................................................23
Tools ..................................................................................23
MAINTENANCE 1 ½” – 8” HYDROMETERS
Hydrometer Removal From Pipeline ................................24
Finger Strainer Cleaning and Replacement ......................25
Register Assembly Removal and Replacement ................25
MAINTENANCE 1 ½” & 2” HYDROMETERS
Hydrometer Cover and Base Assemblies ..........................26
Diaphragm/Stem Dis-Assembly .......................................27
Base and Stem Dis-Assembly ...........................................27
Inlet Spider and Strainer ...................................................28
MAINTENANCE 3” & 4” HYDROMETERS
Hydrometer Dis-Assembly and Re-Assembly ...................29
Hydrometer Cover and Base Sub-Assemblies ..................29
Diaphragm/Stem Assembly and Base Assembly ..............30
Inlet Spider and Strainer ...................................................31
MAINTENANCE 6” HYDROMETERS
Hydrometer Dis-Assembly and Reinstallation .................32
Register .............................................................................32
Hydrometer Cover ............................................................32
Diaphragm and Upper Stem Bearing ................................33
Lower Stem Bearing and Valve Cover ..............................33
Impeller and Flow Tube Sub-Assemblies .........................34
Inlet Spider ........................................................................34
MAINTENANCE 8” HYDROMETER
Hydrometer Dis-Assembly and Re-Assembly ...................35
Register .............................................................................35
Hydrometer Cover ............................................................35
Diaphragm Sub-Assembly ................................................35
Diaphragm Sub-Assembly and Dis-Assembly .................36
Lower Chamber Disc Sub-Assembly ................................36
Stem Sub-Assembly and Valve Cover ..............................37
Impellar and Flow Tube Assemblies .................................38
Inlet Spider ........................................................................38
SCHEMATICS ................................................................39