BlueAnt Q1 Voice Controlled Headset - Manual (Page 16)

16
Pairing
To use the Q1, you need to pair it with your phone. Pairing creates a stored link between the phone
and the headset. Once paired, they will reconnect automatically in future.
The Q1 goes into pairing mode automatically the first time you turn it on.
If you want to go back into pairing mode later on, use the "Pair Me" voice command and follow the
voice prompts.
The instructions below provide some additional information about the pairing procedure, in case you
encounter problems pairing your phone with the Q1.
Pairing Summary
• The Q1 can store pairing information for up to 8 different Bluetooth devices.
• If you pair a 9th device, this pairing will replace the oldest existing pairing stored in the Q1.
• Up to 2 devices can be connected at the same time (multipoint). When you have two phones
connected you can answer whichever one rings.
• If a mobile device is connected to the Q1 and you go into pair mode to pair another device, then
the first device will be disconnected from the Q1.
• If you want to have both phones connected, then you will need to reconnect to the first
phone when you finish pairing the second phone.
• In most cases the phone will reconnect to the Q1 automatically when you finish pairing,
but if this does not happen you should be able to manually reconnect the phone from your
phone's Bluetooth menu.
• You can find out whether you have one or two phones connected by using the "Am I
Connected" voice command.