BlueAnt Q1 Voice Controlled Headset - Manual (Page 21)

21
Charging the Q1
Your Q1 has been given an initial charge to get going, but in future you will need to charge it for up to
2.5 hours.
Use the supplied AC adapter or the USB cable to charge the Q1 whenever the battery is low.
You will be able to tell that the battery is low because the BlueAnt button will flash red when you turn
the Q1 on. You can also check the current battery level using the
"Check Battery" command.
If the battery level drops to very low, then the Q1 will play a low battery sound and automatically
switch itself off.
The battery life on the Q1 will vary depending on the phone you are using: some
phones draw significantly more power than others. In particular, using the Q1 with a
VoIP application such as Skype will drain the battery more quickly.
Charging the Q1 with the USB cable
1. Plug the supplied USB cable into a spare USB socket on your computer.
2. Plug the other end of the USB cable into your Q1.
3. The BlueAnt button on the Q1 flashes red during charging. When the light goes blue, the Q1 is
fully charged. Remove the USB cable from your computer, and disconnect the Q1 from the other
end of the cable.
Charging the Q1 with the AC Adapter
1. Attach the supplied USB cable to the supplied AC adapter.
2. Plug the other end of the USB cable into your Q1.
3. Plug the AC adapter into a power socket.