Pairing procedure – BlueAnt Q1 Voice Controlled Headset User Manual
Page 17
17
Pairing Procedure
1. With the Q1 switched on, press (the BlueAnt button), wait for the Q1 to ask you to "Say A
Command", and then say "Pair Me".
2. The voice prompts will explain that the Q1 is now in pair mode. Bring the mobile phone to within
about 30cm of the Q1.
3. Find the Bluetooth menu in your mobile phone, and turn Bluetooth on.
If you don't know how to do this, refer to the section on pairing or Bluetooth in your phone's
manual, or check with your phone manufacturer for more information on how to enable
Bluetooth on your mobile phone.
4. Use your phone's Bluetooth menu to search for Bluetooth devices. This may take a few minutes,
depending on your phone model.
5. When your phone finishes searching, it will display a list of devices it has found. Select the
BlueAnt Q1 from the list.
6. If your phone prompts you for a password or security code, enter
"0000" (four zeros).
7. Depending on your phone model, it may now connect to the BlueAnt Q1 automatically.
If this does not happen, use your phone's Bluetooth menu options to connect to the Q1.
You are now ready to start using the Q1.
On some phones you may need to change an additional security setting to allow the phone and
headset to reconnect to each other automatically every time they come back into range.
If your phone keeps prompting you to accept the connection from the Q1 every time you bring it back
into range with the Q1, then this applies to you. See
"My Phone Does Not Automatically Reconnect to
for more details on how to change this setting on your phone.