BlueAnt Q1 Voice Controlled Headset - Manual (Page 25)

25
Transferring Audio from the Q1 to your
Phone
The Q1 allows you to switch back to your phone at any time, even while you are on a call.
To disconnect the Q1 from your phone, just click "Vol +" and "Vol -" together. If you are on a call when
you click the buttons, then the audio will be transferred back to your phone where you can continue
the call.
If you disconnect the Q1 while you are on a call, you can switch the audio back to the Q1 again during
the call. Just click the
"Vol +" and "Vol -" buttons together again.
Not all phones support reconnecting to a Bluetooth headset during a call. If clicking
the buttons together does not work, then you will have to wait until the end of the call
to reconnect to the Q1.
If you were not on a call when you disconnected from the Q1, then you will not be able to reconnect by
clicking
"Vol +" and "Vol -" again. In this case you can use the "Am I Connected?" voice command to
reconnect the Q1 to your phone.