BlueAnt Q1 Voice Controlled Headset - Manual (Page 41)

41
Function Button How Long When Notes
Turn LEDs On or
Off "Vol +"
and
"Vol -"
Hold for 1
second Idle This function is only available when the
headset is in Idle mode. It is not available
when the headset is in Standby mode, so
you will need to disconnect from all paired
mobile devices before using this button
combination.
You can turn off the LED without
disconnecting by using the
"LED Light"
command on the "Settings Menu".
Please note that this button combination
also turns the voice control on or off (but
with a longer button press). You must
therefore make sure you release the
volume buttons after 1 second.
Save the last
incoming call in
one of the Q1's
speed dials "Vol -" Hold for 1
second Standby This function is not available if you have
turned off voice control.
For more information about storing
numbers in the Q1's speed dials, see
"Setting Up Speed Dials" (page 23) .
Hold current call
and answer a
second incoming
call "Vol +" Hold for 1
second 3 Way Call This function is only available if your phone
and phone network supports 3 way calling.
End current call
and answer a
second incoming
call "Vol -" Hold for 1
second 3 Way Call This function is only available if your phone
and phone network supports 3 way calling.
Hold current call
and switch to the
call on the other
line "Vol +" Hold for 1
second 3 Way Call This function is only available if your phone
and phone network supports 3 way calling.
Call Conference Hold for 3
seconds 3 Way Call This function is only available if your phone
and phone network supports 3 way calling.