Dell POWEREDGE 2950 - Manual (Page 32)

32
About Your System
PCIe Degraded Link Width
Error: Embedded
Bus# nn /Dev# nn /Func n
Expected Link Width is n
Actual Link Width is n
Faulty or improperly installed PCIe
card in the specified slot. Reseat the PCIe card in the specified
slot number. See "Expansion Cards" on
page 76. If the problem persists, see
"Getting Help" on page 147.
PCIe Degraded Link Width
Error: Slot n
Expected Link Width is n
Actual Link Width is n
Faulty or improperly installed PCIe
card in the specified slot. Reseat the PCIe card in the specified
slot number. See "Expansion Cards" on
page 76. If the problem persists, see
"Getting Help" on page 147.
PCIe Training Error:
Embedded
Bus# nn /Dev# nn /Funcn
PCIe Training Error:
Slot n
Faulty or improperly installed PCIe
card in the specified slot. Reseat the PCIe card in the specified
slot number. See "Expansion Cards" on
page 76. If the problem persists, see
"Getting Help" on page 147.
PCI BIOS failed to install PCI device BIOS (Option ROM)
checksum failure is detected during
shadowing.
Loose cables to expansion card(s);
faulty or improperly installed
expansion card(s).
Reseat the expansion card(s). Ensure
that all appropriate cables are securely
connected to the expansion card(s). If
the problem persists, see
"Troubleshooting Expansion Cards" on
page 127.
Plug & Play Configuration
Error
Error encountered in initializing PCI
device; faulty system board. Install the NVRAM_CLR jumper and
reboot the system. See Figure 6-1 for
jumper location. If the problem persists,
see "Troubleshooting Expansion Cards"
on page 127.
Read fault
Requested sector not found
The operating system cannot read
from the diskette or hard drive, the
system could not find a particular
sector on the disk, or the requested
sector is defective. Replace the diskette. Ensure that the
diskette and hard drive cables are
properly connected. See
"Troubleshooting a USB Device" on
page 115, or "Troubleshooting a Hard
Drive" on page 124 for the appropriate
drive(s) installed in your system.
Remote configuration
update attempt failed
System unable to process Remote
Configuration request Retry Remote Configuration.
Table 1-7. System Messages (continued)
Message Causes Corrective Actions
Book.book Page 32 Friday, February 3, 2006 11:09 AM