Canon mp620 - Manual (Page 32)

(A) To load four photos on the Platen Glass
(B) To load two photos on the Platen Glass
Note
Place the photo(s) at least 0.4 inches / 10 mm away from and in square with the edges of
the Platen Glass.
When loading two or more photos at the same time, place them at least 0.4 inches / 10 mm
apart from each other. If photos are placed closer, they may be scanned as a single
image.
The Skew Correction function automatically compensates for photos placed at an angle of
up to approximately 10 degrees.
Slanted photos with a long edge of 7.1 inches / 180 mm or more cannot be corrected.
If appears on the preview screen, check the followings and reset the photos properly
to scan them again.
- The slant is not too large.
- The photos are not placed too close to the edge of the Platen Glass.
Photos smaller than approximately 1 inch / 25 mm square will not be scanned properly.
The types of photos listed below may not be scanned properly.
- Photos that are non-rectangular or irregular shaped (such as cut out photos)
- Photos that are entirely white
- Photos that have white surrounds
The borders of bordered photos may not be scanned properly. Crop photos if necessary.
Refer to the on-screen manual: Advanced Guide .
(3) Close the Document Cover gently, and press the OK button.
The machine starts scanning.
Important
The photos are rescanned before printing starts. Do not open the Document Cover or move the
loaded photos until printing is completed.
3.
Specify the number of copies.
(1) Make sure that Select and print is selected, and press the OK button.
Note
You can also select useful printing functions other than Select and print.
See Using Various Functions .
(2) Use the Easy-Scroll Wheel or the (Left) or (Right) button to display a
photo to print.
(3) Press the [ + ] or [-] button to specify the number of copies.
Note
Page 32 of 815 pages Reprinting Printed Photos