ITC ProTime Microcoagulation System - Manual (Page 9)

9
SPECIMEN COLLECTION
Fingerstick whole blood is the recommended specimen. The Tenderlett Plus device is to be used with the
ProTime cuvette, and the Tenderlett Plus LV (low volume) device is to be used with the ProTime3 cuvette.
The Tenderlett Plus device will collect approximately 65 µL of blood (approximately 3 drops), while the
Tenderlett Plus LV device will collect approximately 27 µL of blood (approximately 1 large drop). Samples
should be analyzed immediately after collection. No additional sample preparation is required.
For venous samples, collect venous whole blood into an anticoagulant-free plastic syringe in place of
fingerstick sampling steps 3 and 4 of the Test Procedure section. Immediately dispense venous sample
into the Tenderlett Plus collection cup, filling the Tenderlett Plus collection cup. Follow instructions from
step 5 of the Test Procedure section.
Note: Serum, plasma or whole blood collected with any anticoagulants is NOT suitable
samples.
PREPARING THE INSTRUMENT
Unpacking and Inspection
1.
Remove any protective packaging that may be present around the instrument.
2.
Examine the packaging material to be sure that the AC/DC power module, AC power cord (see
note below), connecting cables, or other components have been removed. The materials that are
provided are listed below.
Note: Inspect each component for damage when unpacking. If damage is observed, contact
your ProTime representative.
Materials Provided
Article Quantity
ProTime Microcoagulation Instrument 1
ProTime Microcoagulation System Information and Training CD
(PROTIMEPRO only) 1
AC/DC power module – ITC Part No. IR5226 1
ProTime Microcoagulation Operator’s Manual 1
Note: An AC power cord is provided in the United States and Canada only. For use outside the
US and Canada, the customer must obtain a power supply cord that is internationally
harmonized and marked "<HAR>", 2-conductor, 0.75 mm
2 minimum wire, rated 300 V, with
a PVC insulated jacket. The cord and plug cap must be suitable for medical use. The cord must
have a molded on plug cap rated 250 V, 2.5 A.
Materials Needed But Not Supplied
• ProTime cuvettes
• Tenderlett Plus incision device
Optional Materials
Article
Personal Computer Interface Cable – ITC No. PROCABLE (ITC Part No. IR5313X)
Printer/Label Maker – ITC No. LBLKIT
Replacement Printer/Label Maker Interface Cable – ITC No. LBLCABLE (ITC Part No. IR5314X)
Replacement Battery – ITC No. PROBATTERY