Crestron electronic CHV-TSTAT - Manual (Page 25)

Crestron CHV-TSTAT and CHV-THSTAT Thermostats
MODE
VIEW
T
T
CRESTRON
SETUP: SENSORS
Sensor
Internal:
Remote 1:
Remote 2:
TEMP HUM
USE OMIT
USE OMIT
USE OMIT
Internal Sensor
Temperature/Humidity in CHV-THSTAT
Temperature only in CHV-TSTAT
Remote Sensors
CHV-RTS temperature only sensor
CHV-RTHS temperature/humidity sensor
Sensors may be indoor or outdoor.
Choose USE, OMIT, or Outdoor (OD)
Select Sensor Type
Temperature and/or Humidity
NOTE: Remote 1 and Remote 2 Options do not appear on this screen if these
sensors are not connected.
NOTE: Declared outdoor temperature/humidity sensors should have both TEMP and
HUM declared as OD (Outdoor).
8. SERVICE/TEST
Press the MODE button to access the SERVICE/TEST setup screen. Press VIEW to
select each parameter. Press the Arrow keys (▲▼) to select the value of the
parameter.
• H1 – Single Stage Heating
• H2 – Two Stage Heating
• C1 – Single Stage Cooling
• C2 – Two Stage Cooling.
NOTE: This screen bypasses all system delays and is used by the installer to
manually operate the HVAC system. Only one system can be run at a time.
MODE
VIEW
T
T
CRESTRON
SETUP: SERVICE/TEST
Heat Call:
Cool Call:
Aux Heat Call:
Humidifier Call:
Fan Run Call: OFF
OFF
OFF
OFF
OFF
Heat Call
Choose Off, H1, or H2
Cool Call
Choose Off, C1 or C2
Fan Run Call (ON or OFF)
Aux Heat (ON or Off)
Only appears on heat pump systems
Humidifier Call (On or Off) CHV-THSTAT only
Press MODE button to return to the first screen. Simultaneously press and hold the
MODE and VIEW buttons to return to normal operation mode.
Operations and Installation Guide – DOC. 8163B Thermostats: CHV-TSTAT and CHV-THSTAT • 21