Baumer N 150 - Manual (Page 16)

N 150
www.baumer.com 16
Extended identifier command „AX“ (41h,58h)
This extended command is utilized to address individual SPAs in the bus network in a similar way as described
above. By broadcast command the identifier to be assigned is transmitted to all networked SPAs as follows:
SOH Adr Cmd Cmd2 Identifier = 01 EOT CRC
Transmission
01h 83h 41h 58h 30h 31h 04h 40h
Similar to the standard command all N 150 now indicate the identifier just transmitted and that is to be assigned
in the upper display line. Adopting the identifier is the same way. However, contrary to the above there won’t be
any acknowledging „B“ replied. Checking whether the new identifier has been adopted is up to master,, for
example utilizing command “R” (read actual value). The R-command is transmitted with the corresponding
identifier to the N 150. If the addressed SPA is confirming that the assignment was successful, the master can
proceed with next identifier. Regarding other commands the display of the respective SPA switches to standard
operation.