Baumer N 150 - Manual (Page 8)

N 150
www.baumer.com 8
4.2.4. Read /write offset „U“ (55h)
This command is utilized to read or write the offset that is added to the true actual value. First however the
function must be enabled in command bit parameter ‚a’ (61h).
Example 1: Read offset
SOH Adr Cmd EOT CRC
Transmission
01h 20h 55h 04h 26h
Example 2: Write offset
SOH Adr Cmd Data (offset = –20,00) EOT CRC
Transmission
01h 20h 55h 2Dh 30h 32h 30h 30h 30h 04h C3h
Response in both examples:
SOH Adr Cmd Data (offset = –20,00) EOT CRC
Response
01h 20h 55h 2Dh 30h 32h 30h 30h 30h 04h C3h
4.2.5. Read / write profile number „V“ (56h)
This command is utilized to read the presently active profile number or to alter the profile.
Example 1: Read active profile (active profile number = 38)
SOH Adr Cmd EOT CRC
Transmission
01h 20h 56h 04h 20h
SOH Adr Cmd Profile no. = 38 EOT CRC
Response
01h 20h 56h 33h 38h 04h 28h
Response after reset upon having cleared all profiles:
SOH Adr Cmd Profil-Nr. = FF EOT CRC
Response
01h 20h 56h 3Fh 3Fh 04h 16h
Example 2: Transmit profile (new profile number = 17)
SOH Adr Cmd Profile no. = 17 EOT CRC
Transmission
01h 20h 56h 31h 37h 04h 3E
SOH Adr Cmd Profile no. = 17 EOT CRC
Response
01h 20h 56h 31h 37h 04h 3E
Example 3: New profile to all N 150 by broadcast (identifier = 99 (83h); new profile number = 17)
SOH Adr Cmd Profile no. = 17 EOT CRC
Transmission
01h 83h 56h 31h 37h 04h 04
Response not confirmed
To check whether the new profile has been adopted by all N150 utilize check command „C“ (43h).