Dell POWEREDGE M1000E - Manual (Page 733)

Fabric OS Message Reference 657
53-1001767-01
Chapter
111
ZONE System Messages
ZONE-1002
Message
<timestamp>, [ZONE-1002], <sequence-number>,, WARNING, <system-name>, WWN
zoneTypeCheck or zoneGroupCheck warning(<warning string>) at port(<port number>).
Probable Cause Indicates a zone filter or zone group check failure occurred. The frame filter logic reported a failure
when creating or adding zone groups during port login (PLOGI) trap processing. This messages
usually indicates problems when adding content-addressable memory (CAM) entries before the
filter setup.
Recommended
Action
If the message persists, run the supportFtp command (as needed) to set up automatic FTP
transfers; then run the supportSave command and contact your switch service provider.
Severity WARNING
ZONE-1003
Message
<timestamp>, [ZONE-1003], <sequence-number>,, WARNING, <system-name>,
zone(<current zone>) contains (<domain id>, <port number>) which does not exist.
Probable Cause Indicates the port zone member that is targeted for the local switch contains a non-existent port.
The effective zoning configuration (displayed in the error message) contains a port number that is
out of range.
Recommended
Action
Edit the zone database and change the port number to a viable value in the effective configuration.
Severity WARNING
ZONE-1004
Message
<timestamp>, [ZONE-1004], <sequence-number>,, INFO, <system-name>, port <port
number> (<port number (hex)>) enforcement changed to Session Based HARD Zoning.
Probable Cause Indicates the zoning enforcement has changed to session-based hard zoning. When a device is
zoned using both World-Wide Name (WWN) in one zone and <domain, portarea> in another, this
will cause the port to go to session-based hard zoning.