Dell POWEREDGE M1000E - Manual (Page 755)

Fabric OS Message Reference 679
53-1001767-01
Chapter
114
AUDIT AUTH System Messages
AUTH-1045
Message
AUDIT, <timestamp>, [AUTH-1045], <sequence-number>,, ERROR, <system-name>,
Certificate not present in this switch in <authentication phase> port <port
number>.
Probable Cause Indicates that the public key infrastructure (PKI) certificate is not installed in this switch.
Recommended
Action
Check the certificate availability using the pkiShow command. Install the certificate and reinitialize
authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, run supportFtp command (as needed) to set up automatic FTP transfers;
then run the supportSave command and contact your switch service provider.
Severity ERROR
AUTH-1046
Message
AUDIT, <timestamp>, [AUTH-1046], <sequence-number>,, INFO, <system-name>,
<Operation type> has been successfully completed.
Probable Cause Indicates that the certificate database operation has been updated using the secAuthCertificate
command. The values for Operation type can be "set" or "remove".
Recommended
Action
No action is required.
Severity INFO
AUTH-1047
Message
AUDIT, <timestamp>, [AUTH-1047], <sequence-number>,, ERROR, <system-name>,
<Operation type> has failed.
Probable Cause Indicates that the specified action has failed to update the certificate database using the
secAuthCertificate command. The values for Operation type can be "set" or "remove".
Recommended
Action
Retry the secAuthCertificate command.
Run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command
and contact your switch service provider.
Severity ERROR