Dell PowerVault 124T - Manual (Page 32)

5. Press Enter. New Subnet Mask xxx.xxx.xxx.xxx appears on the LCD. You do not need to reboot the
autoloader.
6. Press Escape or Enter to return to the Ethernet submenu.
Setting an IP Gateway
1. From the main menu, scroll to Configuration, and then press Enter (also see (also see IPv6 Phase 1
Support ).
2. From the Configuration menu, scroll to Ethernet, and then press Enter.
3. From the Ethernet submenu, scroll to Set Gateway, and then press Enter. The cursor automatically
appears at the first digit.
4. At each position of the gateway address, use the up and down arrows to change the value of each
digit. Press Enter to advance the cursor to the next digit.
When you have advanced through all of the digits of the gateway address, the autoloader displays
Enter to save.
NOTE: If you make a mistake, press Escape to backspace to the digit you want to change.
5. Press Enter. New Gateway is xxx.xxx.xxx.xxx appears on the LCD. You do not need to reboot the
autoloader.
6. Press Escape or Enter to return to the Ethernet submenu.
Setting the SNMP Server
An SNMP server monitors a network by processing reporting activity in each network device (hub, router,
bridge, and so on). The server uses this information to define what is obtainable from each device and what
can be controlled (turned off, on, and so on).
NOTE: The PV124T SNMP agent supports only the MIB-II variable group. The MIB provides power-on
notification commonly referred to as the "cold start trap" which is sent to the SNMP host (if configured).
Embedded webserver user interface is supported for configuring the SNMP server. However, extended
SNMP functions such as availability of tape information through SNMP, SNMP traps for tape events,
availability of global tape status information through SNMP, availability of information through SNMP to
classify the loader as a tape device, etc. are not supported.
To set an SNMP server:
1. From the main menu, scroll to Configuration, and then press Enter.
2. From the Configuration menu, scroll to Ethernet, and then press Enter.
3. From the Ethernet submenu, scroll to Set SNMP Server, and then press Enter. The cursor
automatically appears at the first digit.
4. At each position of the SNMP server address, use the up and down arrows to change the value of each
digit. Press Enter to advance the cursor to the next digit.
When you have advanced through all of the digits of the SNMP server address, the autoloader displays
Enter to save.
NOTE: If you make a mistake, press Escape to backspace to the digit you want to change.
5. Press Enter. New SNMP Server xxx.xxx.xxx.xxx appears on the LCD. You do not need to reboot the
autoloader.