Dell PowerVault 124T - Manual (Page 64)

To Remove the Autoloader from a Rack
1. Loosen the two thumb screws that secure the loader to the front of the rack.
2. Using two people, or an appropriately rated mechanical lift, remove the autoloader from the rack by sliding
the autoloader out and supporting it from the bottom.
3. Place the autoloader into the original packaging box, or the packaging from the replacement unit.
Packing the Autoloader
Gather the original packaging material to pack the autoloader: the shipping box, two foam end caps, accessory
package insert (placed at the back of the unit), and the antistatic bag. You will also need packing tape.
1. Place the antistatic bag over the autoloader.
2. Place one of the foam end caps onto each end of the autoloader. Place the second foam insert onto the
other side of the autoloader and make sure the pieces fit snugly onto the autoloader.
NOTE: The foam end caps are not identical. Refer to the diagram on the box flaps for proper
orientation.
3. Place the autoloader into the shipping box and push the front of the autoloader towards the front end of
the box.
4. Insert the accessory package insert at the back of the unit.
NOTE: The accessory package insert is to be placed at the back of the unit, not the front. Refer to the
diagram on the box flaps for proper orientation.
5. Place any necessary paperwork on top of the autoloader inside the box.
6. Close and seal the box.
7. Place the shipping label on the box.
Back to Contents Page