Dell PowerVault 124T - Manual (Page 45)

24 Software Error
25 Hardware Error
Message Error Types
26 Message Sender (Task )
ID Error
Verify the host backup application and device driver are at the
latest supported revision at support.dell.com .
Check host adapter and SAS cables.
Power cycle the autoloader and retry the operation.
If all previous steps fail, see Contacting Dell .
27 Message Type Bad
28 Message Parameter Bad
Stack/Global Data Corruption Error Types
29 Invalid Element Verify the host backup application and device driver are at the
latest supported revision at support.dell.com .
Power cycle the autoloader.
Run the Random Moves test from either the Remote Management
Unit (RMU) or the Operator Control Panel (OCP).
Note: The Random Moves test requires a minimum of two
cartridges present within the autoloader.
If all previous steps fail, see Contacting Dell .
2A Invalid Element Status
2B Element Table Bad
2C Global Data Bad
2D Stack Data Bad
2E Task Stack Low
2F Task Stack Overflow
System Shutdown/Disruption Error Types
30 POST Failure
Verify that the magazines/magazine blank are fully seated.
Power cycle the autoloader.
If all previous steps fail, see Contacting Dell .
31 Watchdog Timer
Power cycle the autoloader.
Run the Random Moves test from either the Remote Management
Unit (RMU) or the Operator Control Panel (OCP).
Note: The Random Moves test requires a minimum of two
cartridges present within the autoloader.
Check support.dell.com for PowerVault 124T firmware updates.
see Contacting Dell .
32 Power Event
33 Power Down Failure
34 System Overload
35 System Performance
36 Asynchronous Stop
System Miscellaneous Error Types
37 System Cleaning Error Cleaning slot in use.
Verify that a valid cleaning cartridge is located in the dedicated
cleaning slot indicated within the Remote Management Unit
Configuration page settings.