Dell PowerVault 124T - Manual (Page 49)

74 Block Erase Failed Verify all SAS cable connections between the host and
autoloader.
Verify no media in drive during update.
Power cycle the autoloader using the front panel power button
and retry the operation.
If all previous steps fail, see Contacting Dell .
75 Flash Program Failed
76 Header Corrupt
77 Checksum Error
78 Timeout During CUP
79 Reset During Drive
Update
7A Unexpected Reset From
Drive
7B Unexpected Message
From PSP
7C Personality or Version
Check Failed
7D Error During Write Buffer
Command
7E Uncompressed EDC
Failure
7F Image Processing Ended
Early
Server Task Error Types
80 Unexpected Response or
Data Received Verify the host backup application and device driver are at the
latest supported revision at support.dell.com .
Check host adapter and SAS cables.
Power cycle the autoloader and retry the operation.
If all previous steps fail, see Contacting Dell .
Servo Elevator Hardware Error Types
92 Elevator Flag Bad
Power cycle the autoloader
Run the Random Moves test from either the Remote Management
Unit (RMU) or the Operator Control Panel (OCP).
Note: The Random Moves test requires a minimum of two
cartridges present within the autoloader.
Check support.dell.com for PowerVault 124T firmware updates.
If all previous steps fail, see Contacting Dell .
93 Elevator Sensor Bad
97 Elevator Calibration Lost
98 Elevator Calibration
Jammed
99 Elevator Lost
9B Elevator Position Error
Picker/Magazine Servo Error Types
A0 Servo Error
Power cycle the autoloader.
Run the Random Moves test from either the Remote Management
Unit (RMU) or the Operator Control Panel (OCP).
Also execute the Recommended Actions for "Open Front" (4B)
error type.
Note: The Random Moves test requires a minimum of two
cartridges present within the autoloader.
Check support.dell.com for PowerVault 124T firmware updates.
A1 Reserved Error Code
A2 Servo Timeout Error
A3 Position Error
A4 Servo Not Calibrated