Troubleshooting – Sony CCD-TRV66 User Manual
Page 66
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Troubleshooting
Symptom
Cause and/or Corrective Actions
The bcTttcrv pack is quicklv
discharged.
• Your camcorder does not operate when you use a battery
pack that is not an "InfoLITHIUM" battery pack.
-> Use an "InfoLITHIUM" battery pack. (p. 11)
• The operating temperature is too low.
• The battery pack is not fully charged.
Charge the battery pack again, (p. 9)
• The battery pack is completely dead, and cannot be
recharged.
Replace with a new battery pack. (p. 8)
The battery remaining
indicator dtx's not indicate
the correct time.
• You have used the battery pack in an extremely hot or
cold environment for a long time.
• The battery pack is completely dead, and cannot be
recharged.
Replace with a new battery pack. (p. 8)
• The battery is dead.
Use a charged battery pack. (p. 8, 9)
The cassette cannot be removed from
the holder.
• The power source is disconnected.
Connect it firmly, (p. 8,12)
• The battery is dead.
Use a charged battery pack or the AC power adaptor.
(p. 8, 9)
The ® and ± indicators flash and no
functions except for cassette ejection
work.
• Moisture condensation has occurred.
-» Remove the cassette and leave your camcorder for at
least 1 hour to acclimatize, (p. 70)
others
Symptom
Cause and/or Corrective Actions
The Remote Commander supplied
with your camcorder does not work.
• COMMANDER is set to OFF in the MENU settings.
Set it to ON. (p. 52)
• Something is blocking the infrared rays.
Remove the obstacle,
• The batteries inserted in the battery holder with the + -
polarities incorrectly matching the + - marks.
Insert the batteries with the correct polarity, (p. 80)
• The batteries are dead.
Insert new ones. (p. 80)
The date or time indicator does not
appear, and the bars "--:--;--"appear.
• Reset the date and time. (p. 58)
The picture from a TV or VCR does
not appear even when your
camcorder is connected to outputs on
the TV or VCR,
• DISPLAY is set to V-OUT/LCD in the MENU settings.
Set it to LCD. (p. 52)
The melodv or beep sounds for 5
seconds.
• Moisture condensation has occurred.
■*
Remove the cassette and leave your camcorder for at
least 1 hour to acclimatize, (p. 70)
• Some troubles has occurred in your camcorder.
Remove the cassette and insert it again, then operate
your camcorder.
While charging the battery pack, no
indicator appears or the indicator
flashes in the display window.
• The AC power adaptor is disconnected.
Connect it firmly, (p. 9)
• Something is wrong with the battery pack.
Contact your Sony dealer or local authorized Sony
service facility.
66