Sony SLV-790HF - Manual (Page 9)

0 Use this hookup if your TV has the S-Link™ function
VCR Stereo receiver
Audio/video cable (supplied)
My hookup: VCR setup
After you've connected your TV and completed antenna or cable hookup,
use the following procedure to set up the VCR.
Press MENU and select
ADVANCED OPTIONS.
IXT3WIB
TIMER SET, CHECK
TUNER PRESET
CLOCK SET
LANGUAGE
SET VCR Plus-t- CHANNELS
CABLE BOX CONTROL
ADVANCED OPTIONS
U s e I t t o s e l e c t a n
I t e m , t h e n push [EXECUTE]
Set AUTO ANT SEL to
OFF and press EXECUTE.
HAVjgMdiwgjgmai
HSfiBSE**oN
AUTO STEREO
DIMMER
AUDIO MIX
NORMAL AUDIO
TAPE SELECT
AUTO TAPE SPEED
APC
SHARPNESS DN DFF
DN DFF
DN
MAIN
DFF
^AP
-120 '160
DN OFF
ON
L -
OFF
- H
For details, see page 66.
Caution
Connections between the VCR's VHF/UHF connector and the antenna terminals of
the TV receiver should be made only as shown in the following instructions. Failure to
do so may result in operation that violates the regulations of the Federal
Communications Commission regarding the use and operation of RF devices. Never
connect the output of the VCR to an antenna or make simultaneous (parallel) antenna
and VCR connections at the antenna terminals of your receiver.
Note to CATV system installer
This reminder is provided to call the CATV system installer's attention to Article 820-
40 of the NEC that provides guidelines for proper grounding and, in particular,
specifies that the cable ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.
Getting Started 9