Troubleshooting – Sony SLV-N77 User Manual
Page 62
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Troubleshooting
If you have any questions or problems not covered below, please consult your nearest Sony
dealer.
Symptom
Remedy
0)
s
O
0.
The 1/1 switch does not function.
• Connect the AC power cord securely.
• Make sure the VCR is not locked. To unlock, hold down
1/1 POWER on the VCR until “EOC” disappears.
The power is turned on but the VCR
does not operate.
• Moisture condensation has occurred. Turn the power off,
unplug the AC power cord and leave the VCR to dry for
over three hours.
o
o
o
The clock has stopped and
appears in the display window.
• The clock stops if the VCR is disconnected from the wall
outlet for more than one minute. Reset the clock (and
timer).
o
n
n
>>
n
0.
The playback picture does not appear
on the TV screen.
• Make sure the TV is set to the channel for the VCR. If
you are using a monitor, set it to video input.
The picture is not clear.
• Adjust the tracking with the TRACKING +/- buttons.
• The video heads are dirty (see the last page of
“Troubleshooting”). Clean the video heads using the
Sony T-25CED or T-25CEDR video head cleaning
cassette. If these cleaning cassettes are not available in
your area, have the heads cleaned at your nearest Sony
dealer (a standard service fee will be charged). Do not
use a commercially available liquid type cleaning
cassette, as it may damage the video heads.
• The video heads may have to be replaced. Consult your
local Sony dealer for more information.
The picture rolls vertically during
picture search.
• Adjust the vertical hold control on the TV or monitor.
The picture has no sound.
• The tape is defective.
• If you made A/V connections, check the audio cable
connection.
O)
c
1
o
o
0)
ai
A TV program does not appear on
the TV screen.
• Make sure the TV is set to the channel for the VCR. If
you are using a monitor, set it to video input.
• Select the correct source with the INPUT SEEECT or
CH +/- buttons. Select a channel number when recording
TV programs; select “El” or “E2” when recording from
other equipment.
TV reception is poor.
• Adjust the TV antenna.
The tape starts playing as soon as it is
inserted.
• The safety tab has been removed. To record on this tape,
cover the tab hole.
The tape is ejected when you press
z
REC.
• Check that the safety tab has not been removed.
Nothing happens when you press
Z REC.
• Make sure the tape is not at its end.
62 Troubleshooting