Arc Machines 205 WDR - Manual (Page 41)

M O D E L 2 0 5
O P E R A T O R ’ S M A N U A L
37 37 37 37
6. The Model 205 features a WELD/TEST button. In the TEST mode the unit will allow for
electrode rotation but will not strike an arc. The WELD or TEST font on the button turns yellow
to indicate which mode the system is set to.
7. When you are ready to start welding press the WELD/TEST button to put the power supply
in WELD mode.
8. Press START to initiate the weld. The center of the RUN screen displays a count-down of
each weld sequence.
Note
For M21 weldheads refer to the Model 21 Weldhead Operation Manual on how to initiate and
stop a weld sequence.