Arc Machines 205 WDR - Manual (Page 53)

M O D E L 2 0 5
O P E R A T O R ’ S M A N U A L
49 49 49 49
8. The START button is located in the upper right corner of the screen. Once you have
determined it is safe to initiate an arc press START. After the arc is established connect
the black and red test probes from the DMM to the shunt (Fig. 3).
9. The weld schedule will remain at each Command level for 15 seconds and advance
through all 10 Commands. During this process make note of the DMM mV reading at each
Command.
10. At the conclusion of the weld sequence enter each of the DMM readings into the SHUNT
column.
11. Press HOME to return to the HOME screen