AVer XR8032_RACK - Manual (Page 102)

96
To Setup Alarm Recording Setting
1. Beside the Start Recording check box, click Detail.
2. In the Alarm Recording Setting dialog box, select the camera to enable/disable video recording. Enable All
to select all cameras.
3. In the Frame Rate selection, select As Setting to record the number of frames based on the Recording
Setting or Max to record the maximum of frames based on the available speed.
4. In the Stop Recording after text box, set the number in second for the program to continue recording after
the alarm has ended.
5. Click
OK
to accept the new settings and Cancel to exit without saving.
To Setup Alarm SOP
Beside the Alarm SOP check box, click Detail. In the step text boxes, type the standard protocol when the alarm
is activated. When the alarm is activated, the Standard Operation Procedure dialog box will appear. Just click
Next
to see the next instruction, Back to see the previous instruction, Finish to end and Abort to terminate.
To Setup CMS Setting
Beside the Send to CMS check box, click Detail. In the CMS Setting, select the camera to enable/disable
sending the video to CMS. Enable All to select all cameras. Then, click OK to accept the new settings and
Cancel
to exit without saving.