AVer XR8032_RACK - Manual (Page 54)

48
detection on eyes of face.
Search Region: User can select condition of face detection and setup face detects area.
- Detect Motion Object: Only when the human face is moved, the system will detect and the face will be
captured.
- Define Select Region: Setup the face detects area. The system will only detect the face in the selected
area. On the preview screen, use mouse to drag the area that user wants to search. User should see the
blue frame on the preview screen of FaceFinder setup window. User can select multiple areas for
detection. To clear the selected area, right click the mouse button and drag the selected area to clear. Or,
click Clear to clear all selected areas.
Detection Sensitivity: To set the sensitivity level of face detection. More higher is more easily to detect the
difference of the face.
Minimal Face Size Level: To set the face detection of minimal size. The system will only detect the face
size is equal or greater than the minimal face size. User should see a green frame on the preview screen
of FaceFinder setup window.
Control Setting of External Device: Set the conditions of the face detection that is trigger by outside
device such as sensor, relay device.
- Activate FaceFinder By External Device: Mark to enable trigger condition.
- Start Message: Set the sensor level that will trigger the face detection. The default is high.
- Stop Message: Set the sensor level that will reset the condition of face detection. The default is low.
- Reaction Device: Set the activate level of relay device. When the face detects condition meets the
condition in Trigger Condition, the relay will send out the signal and the system will send out the face
object log. The log can be viewed in Face Object Log.
- Trigger Condition: Set the condition for activating relay device to send out the log to DVR system. Select
the time (second) and times (the number of face has been detected) from drag down list.
- Reset Device Status After: Set the time period to reset activate device back to normal status. It works
only when the activate status is set to trigger.
After set up, click Start Test to test the configure result. When the system is detecting face, the red frame will
show up on the screen. The test result will display in Face log List windows as below figure shown: