AVer XR8032_RACK - Manual (Page 73)

67
-
- Play Warning Sound
Play alarm sound. To setup click Detail (see also
3.9.2 ).
- Make Phone Calls
Dial and contact the number in the list. To setup click Detail (see also
3.9.3 ). To use this feature, the
PC must have a voice modem connected to it. The supported audio system is only 8KHz and 16Bit
mono.
- Send E-mail
Send an electronic text message. To setup click Detail (see also
3.9.4 ).
- File Transmission via FTP
Upload file to remote computer thru FTP (File Transfer Protocol). To setup click Detail (see also
3.9.5 ).
- Start Recording
Record the video from the selected camera. To setup click Detail (see also
3.9.6 ).
- SMS (Short Message Service)/MMS (Multimedia Messaging System)
SMS transmits only text messages to mobile phone. MMS transmits text messages and images over
wireless networks using the wireless application protocol (WAP). Make sure your mobile phone
support this feature and your PC is connected to GSM/GPRS modem. To setup click Detail (see also
3.9.7 ).
- PTZ preset point
Position the PTZ camera based on the preset point setting. To setup click Detail (see also
3.9.8 ).
- Alarm SOP (Standard Operation Procedure)
List the instructions to inform the person of what to do when the alarm is activated. To setup click
Detail
(see also 3.9.9 ).
- Send to CMS (Central Management System)
Enable/disable the selected camera to send video to CMS when the alarm is activated (see also
3.9.10 )
- Launch Program
To call up the external program that is provided by 3
rd party. Click Detail and click to locate the
program path. Enable Multiple instance check box to allow the program can be executed many
times at the same time.
- Snapshot
Take a snapshot when the alarm is activated.
a. Select Camera: specify which channel video
to be snapshot when the alarm is occurred.
-
Alarm Camera:
when a channel has an
alarm occurred, and then, the DVR system
will snapshot the channel video.
- Camera # (1~32): the selected channel
would be snapshot when an alarm is
occurred.
b. Video Size: select the size of snapshot picture.
c.
Number of picture:
the number of picture that
is going to be taken.
d. Snapshot Interval: a time gap for next
snapshot
e.
Save Path: a storage path for saving snapshot
pictures.