CASO Germany EO27 - Manual (Page 57)

caso EO 27 57
Please note
► In order to ensure adequate ventilation, the back panel of the cabinet
unit must be removed. There must be an aperture of at least 50 mm
between the oven back and cabinet back.
► If the oven is mixed with a different kitchen range, it must observe the
rules which are provided by the manual of the kitchen range.
► In order to get the oven operating normally, the type of cabinet must be
correct.
► Cabinet with a veneer exterior must be assembled with glue which can
withstand temperature up to 120°C.
► In accordance with the safe rules, after installation of the oven, it should
not touch the electric parts.
13.5 Electrical requirements
These appliances must be supplied with proper voltage and frequency
(AC220-240V, 50Hz), and connected to an individual, properly grounded
branch circuit, protected by a circuit breaker. (The voltage on the brand
which located on the frame of oven.)
Warning
► Electrical ground is required on this appliance.
► Do not connect to the electrical supply until appliance is permanently
grounded.
► Disconnect power to the junction box before making the electrical
connection.
► This appliance must be connected to a grounded, metallic, permanent
wiring system, or a grounding connector should be connected to the
grounding terminal or wire lead on the appliance.
► Power supply line should avoid touching the crust sheet metal of the
electric oven. When they touch each other the chances rise that the
oven crust sheet metal will mangle the insulated layer of the power
supply line due to the high temperatures.
► Do not use a gas supply line for grounding the appliance.