CellarPro 4200VSI-B BEER REFRIGERATION SYSTEM, 2177 User Manual
Page 6
6
V9.14
Placement
CellarPro 3200 and 4200 Series cooling units are designed to be installed THROUGH
THE WALL, so that the rear and the front of the cooling unit DO NOT SHARE THE SAME
AIR SPACE.
The rear of the cooling unit must be installed in a space that is at least as large as the
wine cellar unless the rear intake and exhaust are ducted. Both the front and the
rear of the cooling unit require a minimum clearance of 8 inches.
These units also can be placed completely INSIDE or OUTSIDE the cellar when used
in combination with our duct kits.
Ambient Environment
3200VSi / 4200VSi - designed for internal use only (ie sheltered from
outdoor weather), the rear of the unit can be exposed to temperature
conditions ranging from 40 to 115°F.
3200VSx / 4200VSx – designed for external use, the rear of the unit can be
exposed to temperature conditions ranging from 40 to 115°F. Refer to the
Installation section for additional requirements for outdoor exposures.
PLEASE NOTE: With our (optional) crankcase heater, all of our cooling units
can be used in environments down to 20°F, and with our (optional) low
ambient kit, all of our cooling units can be used in environments down to -
20°F.
CellarPro cooling units are
not designed to heat the
cellar
space,
so
if
temperatures
inside
the
cellar drop below proper
wine storage temperatures,
the cooling unit cannot
create heat inside the cellar.
Insulation
CellarPro cooling units are
designed to be installed
inside wine cellars that have
proper insulation, moisture
barriers and an airtight seal
from
the
environment