EFCO 904 Series - Manual (Page 46)

DPS 7/2001
THE SUCCESS OF STRUCTURAL SILICONE GLAZED PROJECTS HAS
BEEN THE RESULT OF COMPATIBILITY TESTS PERFORMED ON
ACTUAL MATERIALS SUPPLIED TO THE PROJECT. THE INSTALLER
MUST MAKE SURE THAT SUCCESSFUL COMPATIBILITY TESTS ARE
PERFORMED IN ACCORDANCE WITH THE SILICONE MANUFACTURER’S
RECOMMENDATIONS AND PROCEDURES.
After the interior sealant has cured, typically an overnight setup is
required. Then remove the temporary glazing clips and proceed with
filling the void between the glass units at the exterior with backer
professional appearance.
rod and structural silicone sealant for a weather tight seal.
Remove excess silicone from the glass surface for a neat and
NOTE:
[FIG. 53]
See Fig. 53 below.
STEP 12)
OF WEATHER SEAL.
SEE THE SILICONE MANUFACTURER’S
INSTRUCTIONS FOR APPLICATION
PAGE 44
SECTION V A - GLAZING PROCEDURES
FOR BUTT GLAZED VERTICAL
(CONT.)