ETS-Lindgren FP2083 Isotropic Electric Field Probes (Archived) - Manual (Page 11)

Isotropic Electric Field Probes
HI-4453/FP5083/FP4083/FP2083
© ETS-LINDGREN L.P. – June 2005
Rev. F, P# H-600064 11
2. GETTING STARTED
UNPACKING AND ACCEPTANCE
Step 1. Upon delivery of your order, inspect the shipping
container(s) for evidence of damage. Record any damage on
the delivery receipt before signing. In case of concealed
damage or loss, retain the packing materials for inspection by
the carrier.
Step
2. Remove the probe and battery charger from their
shipping containers. Save the boxes and any protective packing
materials for future use.
Step 3. Check all materials against the packing list to verify that
the equipment received matches what was ordered. If you find
any discrepancies, note them and call ETS-Lindgren Customer
Service for further instructions.
Be sure that you are satisfied with the contents of your order and
the condition of your equipment before installing the probe.
PROBE
A switch, two fiber optic connectors and a battery charger
connector are mounted on the HI-4453/FP5083/FP4083/FP2083
electronics housing (Figure 2).
XMIT/RCV
The fiber optic cable assembly from the receiver is attached to
the probe via two connectors. The cables are color-coded—
white for XMIT, yellow for RCV. Identically-colored dots are
located on the electronics housing adjacent to these connectors.
Be sure that each cable is attached to the proper probe
connector.
Archived 4/2/10