Archived 4/2/10 – ETS-Lindgren FP2083 Isotropic Electric Field Probes (Archived) User Manual
Page 22
Isotropic Electric Field Probes
HI-4453/FP5083/FP4083/FP2083
© ETS-LINDGREN L.P. – June 2005
Rev. F, P# H-600064
22
Step 2. Briefly describe the problem in writing. Give details
regarding the observed symptom(s) or error codes, and whether
the problem is constant or intermittent in nature. Please include
the date(s), the service representative you spoke with, and the
nature of the conversation. Include the serial number of the item
being returned.
Step 3. Package the system or component carefully. Use the
original packing boxes and materials, if possible.
If the probe is under warranty, refer to the Limited Warranty
section of this manual for additional information about your
return.
PERIODIC/PREVENTIVE MAINTENANCE
The HI-4453/FP5083/FP4083/FP2083 probe assembly (sensor
and electronics housing) requires an annual calibration to verify
that they are performing within specifications. ETS-Lindgren
service personnel may perform this calibration at the factory.
Return your probe(s), using the original packing materials (if
possible), to:
ETS-Lindgren
Attn. Service Department
1301 Arrow Point Drive
Cedar Park, Texas, USA 78613
Archived 4/2/10