ETS-Lindgren FP2083 Isotropic Electric Field Probes (Archived) - Manual (Page 51)

Isotropic Electric Field Probes
HI-4453/FP5083/FP4083/FP2083
© ETS-LINDGREN L.P. – June 2005
Rev. F, P# H-600064 51
5.0 OPERATING INSTRUCTIONS
The 491198-36 battery charger is intended to charge the 3.6 volt
NiCd batteries, either in the lab or in the field.
INPUT POWER REQUIREMENTS
The 491198-36 charger may be powered by standard line
voltage (110 - 240 Vac, 50 - 60 Hz) or by an optional automobile
cigarette lighter plug (12.5 Vdc), see specifications. The AC
power entry module contains a fuse.
FUSE REPLACEMENT
If a fuse has blown, it must be replaced with the same type and
value or an unsafe condition may result. Refer to Figure 2 for
fuse replacement.
The fuse is contained in the fuse drawer in the power input
module. To access the fuse, use a screwdriver to pry the drawer
open and remove it from the module. The drawer holds two
fuses; the fuse towards the outside of the drawer is a spare.
After the fuse has been replaced, slide the fuse drawer back into
the module. Make sure that it snaps securely into its locked
position.
NEVER attempt to change the fuse with
the battery charger plugged in.
Archived 4/2/10