Kontron KISS 4U X9SCAF - Manual (Page 32)

8. Assembly, Disassembly KISS 4U V2 – User's Guide (Version 1.01)
In order to install short expansion cards (half-length), only the card hold down bracket for short
expansion cards (see Fig. 8 and Fig. 9, pos. 7) has to be removed (step 1 to 4).
Fig. 34: Opened KISS 4U V2 platform - removing the card hold down brackets
5. Loosen the internal and then the externally accessible fastening screw that secure the card hold down bracket for
short expansion cards (see Fig. 8 and Fig. 9, pos. 7), (Fig. 34, step 1 and 2). Pull the card hold down bracket to the left
(Fig. 34, step 3) to detach it from the sideways mounted bolts. Lift the card hold down bracket out (step 4). Put the
card hold down bracket and the screws aside for later use.
6. Loosen the internal and then the externally accessible fastening screw that secure the retaining bracket (see Fig. 8
and Fig. 9, pos. 8), (Fig. 34, step 5 and 6). Lift the retaining bracket out (Fig. 34, step 7). Put the retaining bracket
and the screws aside for later use.
7. Loosen the internal and then the externally accessible fastening screws that secure the card hold down bracket for
long expansion cards (see Fig. 8 and Fig. 9, pos. 6), (Fig. 34, step 8 and 9). Pull the card hold down bracket to the left
(Fig. 34, step 10), to detach it from the sideways mounted bolts. Lift the card hold down bracket out (Fig. 34, step
11). Put the card hold down bracket for long expansion cards and the screws aside for later use.
8. Install/remove the expansion card into/out of the expansion slot of the backplane/motherboard and fasten the slot
bracket or the expansion card bracket to the rear slot of the device.
9. Reinstall the card hold down bracket/s and, if applicable the retaining bracket and secure it/them with the screws
retained in step 5, 6 or 7).
1 2
5
6
8 11 9
10
4
3
7
www.kontron.com 31