Kontron KISS 4U X9SCAF - Manual (Page 42)

10. Maintenance and Prevention KISS 4U V2 – User's Guide (Version 1.01)
Fig. 47: Inner sider of the fan slide-in module Fig. 48: Fan slide-in module with inserted filter mat
Legend for Fig. 45 and Fig. 46:
1 Fan slide-in module with two knurled screws
2 Connector for fan control
3 2x fans (temperature controlled
independently from each other)
4 Positioning plate of the fan slide-in module
5 Housing of the fan slide-in module
6 Inserted filter mat holder at the front side of the fan
slide-in module
5. Replace the fan slide-in module with a new functional module.
6. Install the filter mat holder (put aside in step 1) with the filter mat to the front side of the fan slide-in module, as
described in chapter 10.1 “Cleaning the Filter Mat” (step 7 and step 8; see also Fig. 48).
7. Insert the positioning plate (Fig. 47 and Fig. 48, pos. 4) into the fan compartment (Fig. 46, pos. 5) behind the fixing
plate (Fig. 45 and Fig. 46, pos. 2).
8. After the positioning plate (Fig. 47 and Fig. 48, pos. 4) is properly inserted into the fan compartment, push the upper
part of the fan slide-in module into the fan compartment until the fan control connector (Fig. 47, pos. 2) is firmly
inserted into the socket (Fig. 46, pos. 4).
9. Secure the fan slide-in module by fastening the knurled screws.
If step 6 was skipped, the installation of the filter mat holder (with filter mat) has to be performed as
the final step:
‰
Install the filter mat holder (put aside in step 1) with the filter mat to the front side of the fan slide-
in module, as described in chapter 10.1 “Cleaning the Filter Mat” (step 7 and step 8).
1
3 4
5 1 2
2 1
3
6
3
4
www.kontron.com 41