Mercedes-Benz G-Class 2010 Owners Manual - Manual (Page 108)

X Press button & or *.
The stored messages will now be displayed
in the order in which they have occurred.
For malfunction and warning messages,
see “Vehicle status messages in the
multifunction display” (
Y page 203).
i After you have scrolled through all
recorded status messages, the first
recorded message appears again.
Should the vehicle’s system record any
conditions while driving, the number of
messages will reappear in the multifunction
display when the SmartKey in the starter
switch is turned to position
0 or removed
from the starter switch.
Except for high-priority messages, the vehicle
status message memory will be cleared when
you switch off the ignition.
Settings menu
Introduction
In the Settings menu there are two
functions: The function To reset: Press
reset button for 3 secs., with which you
can reset all the settings to the original
factory settings and a collection of submenus
with which you can make individual settings
for your vehicle.
The following settings and submenus are
available in the
Settings menu:
R
Resetting to factory settings
(
Y page 106)
R
Submenus in the Settings menu
(
Y page 107)
R Instrument cluster submenu
(
Y page 107)
R Lighting submenu ( Y page 109)
R
Vehicle submenu ( Y page 111)
R
Convenience submenu ( Y page 111)
Resetting to factory settings
You can reset the settings of all submenus to
the factory settings.
For safety reasons, the function
Headlamp
Mode in the Lighting submenu cannot be
reset while driving.
The following message appears in the
multifunction display:
Cannot be
completely reset to factory
settings while driving.
X Press button V or U repeatedly until
the
Settings menu appears in the
multifunction display.
X Press the reset button in the instrument
cluster (
Y page 98) for approximately
3 seconds.
The request to press the reset button once
more to confirm appears in the
multifunction display.
X Press the reset button once more.
The settings you have changed will not be
reset unless you confirm the action by
pressing the reset button a second time. After
106
Control system
Controls in detail
463_AKB; 3; 35, en-US
d2ureepe,
Version: 2.11.8.1
2009-07-16T20:59:56+02:00 - Seite 106