Navigation, Introduction – Mercedes-Benz SLK-Class 2009 COMAND Manual User Manual
Page 51
Update Sequence
The sequence includes the following stages:
R
Loading DVD into the DVD changer
R
Update process
i
The update process may take between 60
and 150 minutes, depending on the size of
the map software.
If possible, perform the update when the
vehicle is stationary. The DVD read speed
is faster when the vehicle is stationary than
when the vehicle is moving and the update
therefore takes less time. If you perform
the update with the engine off and the
vehicle battery is no longer powerful
enough, COMAND may shut off
automatically during the process to protect
the battery. In this case, restart the update
with the engine running.
You can interrupt the update process and
continue it at later time. If you cancel the
update process, the navigation system is
not ready for operation.
G
Warning
Never leave the engine running in an enclosed
space. The exhaust gases contain carbon
monoxide. Inhaling exhaust gases constitutes
a health hazard and could lead to loss of
consciousness or even death.
Loading DVDs into DVD Changer
The 6-disc DVD changer is integrated with
COMAND.
1
Load/Eject button
2
Disc slot
X
Press the Load button 1.
A disc icon indicates which magazine
compartments are currently loaded.
X
To select an empty magazine
compartment: Press ; or =.
X
To start loading: Press 9.
The message Please Insert Disc <x>
will then be displayed.
X
Insert the DVD into the slot with the printed
side upwards.
The DVD changer pulls in the DVD. The
message Loading Disc <x>... will be
displayed.
i
If the magazine is full, you will first need
Update Process
The update process starts once the DVD has
been loaded.
COMAND checks whether the map software
on the DVD matches the vehicle's navigation
system and system software.
Map Software Is not Suitable for the
Navigation System or the System
Software
A message is displayed stating that the
navigation update DVD with the new map
data is not suitable for the system or the
system software.
COMAND ejects the DVD.
X
Remove the DVD from the slot 1.
X
Have the system software updated by an
authorized Mercedes-Benz Center.
i
It will only be posssible to update the map
software once the system software has
been updated.
Map Software Matches the Navigation
System and the Current System Software
COMAND checks whether the DVD's map
data has already been installed.
Introduction
49
Navigation
Z