Entering stopover destination, Navigation, Destination input – Mercedes-Benz SLK-Class 2009 COMAND Manual User Manual
Page 73
Opening the Map
X
If at least a city has been entered, select
Map in the Enter Destination menu
(
or
X
If necessary, display the menu system in
the map display .
X
Select Destination£Using Map.
In both cases, the map together with
crosshairs appears.
1
Current vehicle location
2
Crosshairs
3
Information on crosshairs position
4
Set map scale
i
The display 3 depends on the settings
selected in “Information On Map”
(
page 59). It may display the current road
if corresponding data is available in the
digital map. Or it displays the geo-
coordinates position of the crosshairs if
Geo-coordinates display is activated
and if there is adequate GPS reception.
Moving the Map and Selecting a
Destination
X
To move the map: Press
9, :, ; or =.
X
To set the map scale: Press U or
T.
The map scale is displayed.
X
To select a destination: Press 9 once or
repeatedly until you get a list of
destinations if available.
X
To select a destination: Press : or
9.
X
Press 9.
If the destination is within the digital map,
COMAND tries to find the destination on
the map.
If the destination can be found, the Enter
Destination menu is displayed with the
address of the destination. Otherwise you
will see the entry Destination From
Map.
X
To start route calculation: Select Start.
Entering Stopover Destination
i
When route guidance is activate, you can
enter a stopover destination. Stopover
destinations may be predefined
destinations in the following categories
suggested by COMAND for you to select:
Destination Input
71
Navigation
Z