Rice Lake 880 Performance Series Panel Mount Indicator/Controller - ProfiNet Interface Option Installation and Programming Manual User Manual
Page 10
6
ProfiNet Installation and Programming Manual
14. Once the module is properly seated, tighten the screws on the front to
0.25Nm using a T8 Torx bit (PN 158153, not included) to secure the module
to the option card.
Tighten Screws
Figure 2-8. Secure Module to Option Card
15. Slide backplate with boards into enclosure, ensuring that each board is
seated correctly in the grooves of the enclosure.
Note
Ensure the enclosure is in the upright position, otherwise the connector
for the display will not align with the front cut. The DIN Rail clips will be at
the bottom.
Ensure boards are
seated properly in
the grooves of the
enclosure.
Corner screws
Din Rail Clip
Figure 2-9. Boards Installed in Controller Assembly Enclosure
16. Reassembly control box to the DIN rail.
17. Reconnect all connectors to the back of the controller assembly.
18. Reconnect power to the indicator.
The indicator automatically recognizes all installed option cards when the unit is
powered on. No hardware-specific configuration is required to identify the newly-
installed card to the system.