Rice Lake 880 Performance Series Panel Mount Indicator/Controller - ProfiNet Interface Option Installation and Programming Manual User Manual
Page 7
Rotate left and right
clip down away from
the DIN rail.
Controller
Assembly
DIN Rail Clip Bracket
Cable Assembly
A slot is provided for a
screwdriver to lift the
positioning dimple from
the locating hole prior to
rotating the lever.
Installation
3
Figure 2-2. Remove Controller Assembly
3.
Rotate left and right hooks away from the DIN rail clip.
4.
Carefully remove the controller box from the DIN rail.
5.
Disconnect the display cable harness.
6.
Loosen the four corner screws and carefully pull the backplate straight out
from the enclosure. The boards are still connected to the backplate and will
slide out of the enclosure.
Note
All boards will slide out together. The power supply board and the CPU
board are connected by a cable.
Figure 2-3. Remove Backplate With Boards
7.
Remove the cable connecting the boards.
8.
Remove the power board and CPU board from the backplate by loosening
the screws holding them in place.