Rice Lake Counting Scales - IQ6500 Installation and Operation Manual - Manual (Page 12)

9
3.3.3 Digital Tare Entry
1. Press 0, then TARE to reset any tare.
2. Press REZERO. After resetting, displays show zero.
3. Use keypad to enter number 0.2, then press TARE. For digital tare entry, decimal must be in appro-
priate place as they would be displayed in Weight display. For example, .250 would be entered as
“0.250”, not “.250”. The Weight display shows weight entered with a negative sign indicating that it
is a tare weight.
3.3.4 Weight, Unit Weight, and Quantity Display
1. From previous step, there should be a tare weight showing in Weight display. If it has been acciden-
tally cleared out, re-enter weight since Quantity display will not be activated unless a weight is
displayed.
2. Enter number 123 through keypad and press PIECES. The display shows all dashes momentarily and
then an accuracy number such as ACC 99.98 (99.98%) is displayed on the Weight and Unit Weight
displays. After a moment, 123 appears in Quantity window, and a unit weight is also computed and
displayed. This operation takes a few seconds.
Note:
The accuracy number function can be turned off (default setting) using SPEC09. For more informa-
tion, see Section 6.0, Setting Configuration.
3.3.5 Accumulation
After the previous step, the Quantity display shows 123.
1. Press +. Blank lines are momentarily shown, then Unit Weight display shows 123. The Quantity
display shows totAL. The memory lamp glows. After a moment, scale resumes operation mode. Since
weight and unit weight have not been changed, Quantity display continues to show 123.
2. Press + again. The Weight display momentarily goes blank, Quantity display shows totAL, and Unit
Weight display shows accumulated value of 246.
3. Press * to clear memory. The Memory lamp goes out.
3.3.6 Fixed Sample
After the previous test, the Weight display shows -0.2.
1. Press 0, then UNIT WEIGHT. The unit weight is cleared.
2. Press PIECES. The Quantity display shows 10 and a unit weight is displayed.
3. Press TARE to clear tare weight.