Rice Lake Counting Scales - IQ6500 Installation and Operation Manual - Manual (Page 6)

3
2.3 Unlocking and Locking
Your IQ6200/6500 scale is delivered in a locked position to prevent
damage to the load cells during shipment. Use the following procedure
to unlock the scale.
1. On underside of scale, use wrench to remove nut (1).
2. Use allen wrench provided with scale to turn bolt (2) in a
counterclockwise direction and remove. Two nuts and two
bolts must be removed on an IQ6500 dual scale as shown in
diagram to right.
Nuts and bolts should be taped to the bottom of the scale or stored in
some other safe location for possible future shipment.
Scales must
be locked prior to shipment .
2.4 Setting-Up
1. Place scale on a level surface.
2. While watching level bubble guide on front of scale, level scale using adjustable legs.
2.5 Powering-Up the IQ6200
The IQ6200 can be operated from an AC adaptor cord or with an optional rechargeable battery pack (DC
power) that allows the unit to be completely portable. A fully-charged battery allows approximately 11 hours
of continuous operation and then requires approximately 8 hours of recharging. The battery will recharge
when the AC adaptor cord is plugged in regardless of whether the scale is on.
To power-up the IQ6200 with the AC adaptor cord:
1. Plug AC adaptor cord into a grounded AC 117 VAC receptacle.
2. Press ON/OFF and allow scale to warm up for 10 minutes. The display momentarily shows revision
number, shows all digits from 0 to 9 in a “count-up” mode, goes blank, shows all 8s, and then enters
regular weighing mode.
To power-up the IQ6200 with the battery option:
1. Remove AC adaptor cord from back of scale.
2. Press ON/OFF and allow scale to warm up for 10 minutes. The display momentarily shows revision
number, shows all digits from 0 to 9 in a “count-up” mode, goes blank, shows all 8s, and then enters
regular weighing mode.
Note:
If the scale displays erratic data, it may be caused by a power transient. Turn the scale off and momentarily
unplug it from the wall outlet. Then restart by plugging the scale back in and pressing ON/OFF. The scale
will go through a display check, and no warm up is needed.
1
2