Rice Lake Counting Scales - IQ6500 Installation and Operation Manual - Manual (Page 40)

37
12.3 Eltron Printer Interface
The Eltron printer interface option, PN 41278, allows the IQ6500 counting scale to connect to all Eltron
printers except models LP 2022 and LP 2042. The factory-installed option consists of a custom EPROM for
the IQ6500 and a 25-to-9 pin D-SUB interface cable, PN 41279. The baud rate for the IQ6500 is set to 9600
bps by changing the jumper as shown in the figure below.
See Section 9.3 for information about interface cable pin connections and spec code settings for the Eltron
printer interface.
JP2 JP3 JP4 JP1
JP5 JP6
Special EPROM for
Eltron Interface
Chassis Ground Wire
Jumper Position at
JP3 for 9600 baud
Bubble Level
on Chassis